Welcome Guest. ( logon | register )   
FAQ Member List Albums Today's Posts Search

PointedThree :  Sedan Forums : W126 S,SE,SEC,SEL,SD,SDL Class : Help iwith a few wires

Page 1 of 1 1
Help iwith a few wires
Topic Tools Message Format
Author
Posted 11/4/2006 11:07 PM
Rolex

Date registered: Dec 1899
Location:
Vehicle(s):
Help iwith a few wires

Can anyone tell me where these few wires go?




(DSC00200.JPG)



(DSC00201.JPG)



Attachments
----------------
Attachments DSC00200.JPG (143KB - 247 downloads)
Attachments DSC00201.JPG (146KB - 238 downloads)
#51831
Top of the page Bottom of the page
Author
Posted 11/5/2006 9:43 AM
cmitch
Expert




Date registered: Apr 2006
Location: Ala-Tenn
Vehicle(s): 2002 ML320, 2018 GLE350, 2010 F150 Super Crew
Posts: 3413
2000
RE: Help iwith a few wires

Do you always remove your fuse block and wiring harness when working on your car? Disconnecting the battery cable would be much easier.
#51874 - in reply to #51831
Top of the page Bottom of the page
Author
Posted 11/5/2006 6:18 PM
BenzDieselTuner

Date registered: Dec 1899
Location:
Vehicle(s):
Re: Help iwith a few wires

tell me dammit!
#51917 - in reply to #51831
Top of the page Bottom of the page
Author
Posted 11/15/2006 3:29 AM
shrimpton

Date registered: Dec 1899
Location:
Vehicle(s):
Re: Help iwith a few wires

Did you use a couple of steel rims as cable drums?.
#53187 - in reply to #51831
Top of the page Bottom of the page
Author
Posted 11/15/2006 4:33 AM
NZ Benz
Expert


Date registered: Apr 2006
Location: New Zealand
Vehicle(s): 1993 300SEL/S320
Posts: 2555
2000
Re: Help iwith a few wires

Rolex - 11/6/2006 8:11 PM

80 Pounds was the weight of the last one I sent out. (Front to back entire harness)


Thats quite a bit, but when you think if they wired everything with copper it's about right, almost makes recovery of the copper for scrap value worth it, well not quite.
#53192 - in reply to #51917
Top of the page Bottom of the page
Author
Posted 11/16/2006 2:57 AM
shrimpton

Date registered: Dec 1899
Location:
Vehicle(s):
Re: Help iwith a few wires

The wiper motor must hold a half pound or so of copper, but 80lb in the harness alone...shiite!.
#53284 - in reply to #51831
Top of the page Bottom of the page
« View previous thread :: View next thread »
Page 1 of 1 1
Forum Jump :
All times are EST.  The time is now 5:02:22 PM.

Execution: 0.156 seconds, 94 cached, 11 executed.