|
Inkblotz
Expert
Date registered: Apr 2006
Location: Georgia
Vehicle(s): 90 300GD "Thundering Turtle II", w/ 603A turbo
Posts: 3186
| External rocker cover
My rocker panel cover was badly cracked and the holding screws were rusty. I looked up the part # from the EPC ordered it, received it and found it to be about 4 inches too short even though it says in the description that they are the extended versions. They will not reach under/into the notched area in the factory fender flare recesses. I am now not sure which is the proper part number with the correct length.
The part numbers I ordered are: 4636902762, 4636902662
Here are other part numbers for them but still not clear which are the extended ones that came with my truck.: 4636901262, 4636902362, 4636901362
Anyone know what the correct part number is?
Thanks
Mark |
|
| |
|
Otiswesty
Administrator
Date registered: Jun 2007
Location: Portland, Oregon
Vehicle(s): 463.241, 461.213
Posts: 3004
| Re: External rocker cover
Hi Mark, bummer they are too short for your SWB. I would suggest getting the MBUSA ones and trimming them down if you are thinking of ordering more. They will be a little too long, but that is more easily remedied than too short. I gave Kent a set of LWB rocker covers for his frankencabrio, I suspect he has done the same. |
|
| |
|
EuroTruck
Extreme Veteran
Date registered: Apr 2006
Location: Oakwood, Georgia - USA
Vehicle(s): 2012 Audi A4 Avant S-Line, 2015 Ridley NOAH SL
Posts: 518
| RE: External rocker cover
Mark,
You ordered the rocker moldings for after VIN 088780. Since your VIN ends in 072952, you actually need two pieces of A 463 690 12 62 according to the EPC.
The length of this molding (A 463 690 12 62) is 54.75 inches / 139 cm for reference.
I have it in stock if you want to check it in person.
-Sean Philyaw |
|
| |
